| ??? 12/08/08 18:00 Read: times |
#160745 - a guess Responding to: ???'s previous message |
OK, I can download a Metalink .DBG file, and open the corresponding .asm source file in Silabs. I can see the registers etc, and trace through the assembler. However, if I try to set a breakpoint I get a message "No address correlation for line number XX", even though the trace through the source works fine.
do you open the source filke in the same directory it was built from? Erik |
| Topic | Author | Date |
| Need some advise on Silabs development in assembler... | 01/01/70 00:00 | |
| OMF-51? | 01/01/70 00:00 | |
| Not sure what you mean... | 01/01/70 00:00 | |
| I can't see why not... | 01/01/70 00:00 | |
| Found it! | 01/01/70 00:00 | |
| assembler | 01/01/70 00:00 | |
Thanks Maarten. | 01/01/70 00:00 | |
| SDCC | 01/01/70 00:00 | |
| just curious | 01/01/70 00:00 | |
| I believe | 01/01/70 00:00 | |
| I hope so... | 01/01/70 00:00 | |
| Try the Metalink Assembler | 01/01/70 00:00 | |
| Thanks... | 01/01/70 00:00 | |
| does anyone have the install file for Silabs pre 1.3? | 01/01/70 00:00 | |
| Your Keil Understanding | 01/01/70 00:00 | |
| objcopy info | 01/01/70 00:00 | |
| That may be difficult | 01/01/70 00:00 | |
| That's good enough... | 01/01/70 00:00 | |
| Partial success... | 01/01/70 00:00 | |
| a guess | 01/01/70 00:00 | |
| Yes. | 01/01/70 00:00 |