Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/30/01 01:42
Read: times


 		 #16143 - Video signals using 89c52
Hello Everybody!

I would like to know if is possible to generate video signals using the atmel 89c52 only by means of software (without a dedicated video chip)I saw a similar project using PIC but I dont know if th 89c52 have enough processing power to do that

Best Regards
Marcelo junior (Brazil)


List of 23 messages in thread
TopicAuthorDate
Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
the article            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
Video signals using 89c52            01/01/70 00:00      
RE: Video signals using 89c52            01/01/70 00:00      
RE: Video signals using 89c52            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      

Back to Subject List