Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
05/15/00 00:43
Read: times


 		 #2668 - RE: Using a 89C52 to drive a stepper motor
1. Refer to the data sheet of DS2004(National Semiconductor) it need more the 5 voltage(around 5 to 8 voltage depend on output current) to drive input pin. If possible change it to DS2003.

2. Add pulling high resistor to the output control pin of 89c52 around 4.7Kohm to get more driving current.

List of 23 messages in thread
TopicAuthorDate
Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
the article            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
Video signals using 89c52            01/01/70 00:00      
RE: Video signals using 89c52            01/01/70 00:00      
RE: Video signals using 89c52            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      
RE: Using a 89C52 to drive a stepper motor            01/01/70 00:00      

Back to Subject List