| ??? 12/01/03 14:15 Read: times |
#59704 - RE: This is the way to go - Steve Responding to: ???'s previous message |
Calibration of the new pot is an issue but that is also well under control
One way to handle this is to "glue" a eeprom onto the pot with the calibration. This method is, for instance, used to allow loadcell replacement without recalibration. Erik |
| Topic | Author | Date |
| Direction Bit for Encoder | 01/01/70 00:00 | |
| RE: Direction Bit for Encoder_RPM | 01/01/70 00:00 | |
| RE: Direction Bit for Encoder_RPM | 01/01/70 00:00 | |
| RE: Direction Bit for Encoder_RPM | 01/01/70 00:00 | |
| Search - Steve | 01/01/70 00:00 | |
| RE: Search - Steve | 01/01/70 00:00 | |
| Alternate solutions - Steve, Erik | 01/01/70 00:00 | |
| RE: Alternate solutions - Steve, Erik | 01/01/70 00:00 | |
| RE: Alternate solutions - Steve, Erik | 01/01/70 00:00 | |
| RE: Pot solution - Steve | 01/01/70 00:00 | |
| RE: Pot solution - Steve | 01/01/70 00:00 | |
| RE: This is the way to go - Steve | 01/01/70 00:00 | |
| RE: This is the way to go - Steve | 01/01/70 00:00 | |
| RE: This is the way to go - Steve | 01/01/70 00:00 | |
RE: This is the way to go - Steve | 01/01/70 00:00 | |
| RE: Alternate solutions - Steve, Erik | 01/01/70 00:00 | |
| RE: Direction Bit for Encoder_RPM | 01/01/70 00:00 | |
| RE: Direction Bit for Encoder_RPM | 01/01/70 00:00 | |
| RE: Direction Bit for Encoder_RPM | 01/01/70 00:00 | |
| RE: Direction Bit for Encoder_RPM | 01/01/70 00:00 | |
| RE: Direction Bit for Encoder_RPM | 01/01/70 00:00 |