| ??? 12/02/04 09:47 Read: times |
#82366 - just TI=1 Responding to: ???'s previous message |
just set tis bit by software: TI=1;By this way, if you use interrupts then serial ISR will be executed when it is allowed. If you do not use the interrupt then it allows pass through while(!TI); at first time. Regards, Oleg |
| Topic | Author | Date |
| THE TIME OF TI | 01/01/70 00:00 | |
| Bitrate | 01/01/70 00:00 | |
| interrupt-driven | 01/01/70 00:00 | |
| Why interrupt driven? | 01/01/70 00:00 | |
| UART Serial Port Interrupt | 01/01/70 00:00 | |
| all the above | 01/01/70 00:00 | |
| UART communication by UART interrupt | 01/01/70 00:00 | |
| just TI=1 | 01/01/70 00:00 | |
| serial interrupt in adc interrupt | 01/01/70 00:00 | |
| start with something simple | 01/01/70 00:00 | |
| misunderstand behaviour | 01/01/70 00:00 | |
| See the examples | 01/01/70 00:00 | |
| not has to, but can | 01/01/70 00:00 | |
| The difference is | 01/01/70 00:00 | |
| " | 01/01/70 00:00 | |
| He's right | 01/01/70 00:00 | |
| How the 8051 UART works | 01/01/70 00:00 | |
| The TI-bit Set Time | 01/01/70 00:00 | |
| no, at the middle | 01/01/70 00:00 | |
| The Transmitter Part, Actually | 01/01/70 00:00 | |
| Setting of TI | 01/01/70 00:00 | |
| sometimes chip designers listen | 01/01/70 00:00 | |
| So, Erik | 01/01/70 00:00 | |
| where does it happen | 01/01/70 00:00 | |
| Mode 1 TI timing. | 01/01/70 00:00 | |
| How to post code | 01/01/70 00:00 | |
RS485 & bus turnaround | 01/01/70 00:00 |