| ??? 01/03/05 19:20 Read: times |
#84282 - baud rates Responding to: ???'s previous message |
i am only using the rs-232 to flash program the T89C51CC02 microcontroller and write to screen. So the baud rate probably isnt too improtant. However, we may use the built-in CAN controller for networking with an embedded pc? So if the 12MHz osc can be used for some baud rates i can send out an accurate 40kHz signal? |
| Topic | Author | Date |
| how can i do a40kHz signal for 10 cycles | 01/01/70 00:00 | |
| whole numbers | 01/01/70 00:00 | |
| baud rates | 01/01/70 00:00 | |
| CAN baud rate | 01/01/70 00:00 | |
| Tutorials and the Bible | 01/01/70 00:00 | |
| reply | 01/01/70 00:00 | |
| Thanks for the advice | 01/01/70 00:00 | |
| Actually... | 01/01/70 00:00 | |
| And what about 2x Xtal? | 01/01/70 00:00 | |
| 40Khz for 10 cycles | 01/01/70 00:00 | |
| Run the numbers | 01/01/70 00:00 | |
or | 01/01/70 00:00 | |
| Don't forget | 01/01/70 00:00 | |
| Resonance | 01/01/70 00:00 | |
| 12MHz would not work, either | 01/01/70 00:00 | |
| 22.118MHz for signal and CAN | 01/01/70 00:00 | |
| CAN CAN | 01/01/70 00:00 | |
| CAN and 'CC02 | 01/01/70 00:00 | |
| some correction | 01/01/70 00:00 | |
| Get 40,000 kHz T2 auto reload 12 mHz | 01/01/70 00:00 | |
| sounds like an application for a PCA | 01/01/70 00:00 | |
| ... and this IS an RD2 | 01/01/70 00:00 |