??? 01/05/05 05:50 Read: times |
#84347 - CAN CAN Responding to: ???'s previous message |
Rob Woodhouse said:
Apparently CAN requires baud rates to be accurate within 0.5%?? This is correct (or close) (sorry, in hotel room on the road with a good buzzon). If you plan on using CAN, 22.18MHZ osc crystal has worked well for me and I would recomend as a good choice, although I have no experience with atmel chips, I use SILABS C8051F040. Hope this helps Andy |
Topic | Author | Date |
how can i do a40kHz signal for 10 cycles | 01/01/70 00:00 | |
whole numbers | 01/01/70 00:00 | |
baud rates | 01/01/70 00:00 | |
CAN baud rate | 01/01/70 00:00 | |
Tutorials and the Bible | 01/01/70 00:00 | |
reply | 01/01/70 00:00 | |
Thanks for the advice | 01/01/70 00:00 | |
Actually... | 01/01/70 00:00 | |
And what about 2x Xtal? | 01/01/70 00:00 | |
40Khz for 10 cycles | 01/01/70 00:00 | |
Run the numbers | 01/01/70 00:00 | |
or![]() | 01/01/70 00:00 | |
Don't forget | 01/01/70 00:00 | |
Resonance | 01/01/70 00:00 | |
12MHz would not work, either | 01/01/70 00:00 | |
22.118MHz for signal and CAN | 01/01/70 00:00 | |
CAN CAN | 01/01/70 00:00 | |
CAN and 'CC02 | 01/01/70 00:00 | |
some correction | 01/01/70 00:00 | |
Get 40,000 kHz T2 auto reload 12 mHz | 01/01/70 00:00 | |
sounds like an application for a PCA | 01/01/70 00:00 | |
... and this IS an RD2 | 01/01/70 00:00 |