| ??? 01/21/05 09:37 Read: times |
#85473 - Opto input Responding to: ???'s previous message |
I would never attach an opto directly to a port pin, I would use a schmitt trigger, like an ls14.
Design component values for 5V operation are typically, for things like an H11A1, 150R (input resistor) and 220 R load resistor - 5V rails. Your mileage may vary. Steve |
| Topic | Author | Date |
| Inputs | 01/01/70 00:00 | |
| Opto | 01/01/70 00:00 | |
| Opto input | 01/01/70 00:00 | |
| Optocoupler Designer’s Guide | 01/01/70 00:00 | |
| What type of opto? | 01/01/70 00:00 | |
| pulling high | 01/01/70 00:00 | |
| Why??? | 01/01/70 00:00 | |
| Misleading.... | 01/01/70 00:00 | |
| OK, clearer | 01/01/70 00:00 | |
| I must be stupid... | 01/01/70 00:00 | |
| you are not | 01/01/70 00:00 | |
| Heres Why | 01/01/70 00:00 | |
| Not quite so. | 01/01/70 00:00 | |
| Pull-downs must be much smaller! | 01/01/70 00:00 | |
| OK you are right. | 01/01/70 00:00 | |
A little history | 01/01/70 00:00 | |
| Link... | 01/01/70 00:00 | |
| use opto-coupler as NPN | 01/01/70 00:00 | |
| Thank you All, & a question for Kai | 01/01/70 00:00 | |
| Opto to pull-down signal | 01/01/70 00:00 |