| ??? 12/20/06 08:01 Read: times |
#129801 - You can not do both Responding to: ???'s previous message |
First Clr TI before you start, to be sure it is clear.
If you are using TI in Both the main code an the interupt, it must be cleared in the interupt. Look at what your code will do, sometimes. Code Running - TI sets- Int Clears TI - Main Code misses it. Make you own flag. Set it in the INT, check and clear it in main. Avoid Dead loops, you can get stuck there. |
| Topic | Author | Date |
| the nature of the UART/steping through interrupts | 01/01/70 00:00 | |
| Uart is full duplex | 01/01/70 00:00 | |
| Thanks Russell | 01/01/70 00:00 | |
| UART Question Part 2 | 01/01/70 00:00 | |
| You can not do both | 01/01/70 00:00 | |
| In response to Neil | 01/01/70 00:00 | |
| go with the bit | 01/01/70 00:00 | |
| In response to Neil | 01/01/70 00:00 | |
| In response to Neil | 01/01/70 00:00 | |
| Sorry for teh tripple post... | 01/01/70 00:00 | |
| More... | 01/01/70 00:00 | |
| Search and Read | 01/01/70 00:00 | |
| Thanks Russell | 01/01/70 00:00 | |
| I hope Russell did not lead you down the garden pa | 01/01/70 00:00 | |
| Erik - garden path indeed! | 01/01/70 00:00 | |
| I'm using interrupts | 01/01/70 00:00 | |
| Question about my interrupt driven UART | 01/01/70 00:00 | |
| You know the answer. | 01/01/70 00:00 | |
| Thanks Russell | 01/01/70 00:00 | |
answer is partially incorrect | 01/01/70 00:00 | |
| Can't single step on UART | 01/01/70 00:00 |