Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/21/07 03:05
Read: times


 		 #133386 - Yes, I did search on this forum
Responding to: ???'s previous message
Thanks Oleg for providing me with the links.

After I had posted my problem, I did search in this forum.
I have tried implementing all the suggestion suggested on this forum.
The USB driver provided in Flip 2.4.6 is not accepted whenever I try updating the Driver.

As a matter of fact, I have remounted the entire circuit required for ISP programming (using USB port) on a General Purpose PCB.

And still, I have not achieved success as of yet.
I will surely go through the links that u have provided me.

Sushil...........

List of 29 messages in thread
TopicAuthorDate
Atmel 89C5131A-M            01/01/70 00:00      
   bootloader            01/01/70 00:00      
      Thanks Oleg            01/01/70 00:00      
   USB interface for ISP programming.            01/01/70 00:00      
      did you try search the forum?            01/01/70 00:00      
      same problem            01/01/70 00:00      
      need some help            01/01/70 00:00      
         Have you looked here?            01/01/70 00:00      
            no success            01/01/70 00:00      
               Driver            01/01/70 00:00      
      Same problem - with setup details - HELP!            01/01/70 00:00      
         Re:6V            01/01/70 00:00      
            Well boy is my face red....            01/01/70 00:00      
   Yes, I did search on this forum            01/01/70 00:00      
      Atmel 89C5131A USB driver.            01/01/70 00:00      
         usb driver            01/01/70 00:00      
   Atmel 89C5131A USB Driver            01/01/70 00:00      
      usb            01/01/70 00:00      
         Atmel 89C5131A USB Driver            01/01/70 00:00      
            i do not know your chip, but            01/01/70 00:00      
               Always exceptions are there :-)            01/01/70 00:00      
                  well, now I have seen one            01/01/70 00:00      
      thank you            01/01/70 00:00      
         have you measured the PLLF pin            01/01/70 00:00      
            Please check the PLLF            01/01/70 00:00      
               XTAL for USB            01/01/70 00:00      
            89c5131            01/01/70 00:00      
            89c5131            01/01/70 00:00      
   from the peanut gallery            01/01/70 00:00      

Back to Subject List