Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/01/08 21:18
Read: times


 		 #158738 - correct me if i am wrong
Responding to: ???'s previous message
the absolute address of p3 would be 0xB0 but as u can see in the code above i have only referenced it once that too only in the define part in the header file . every where else i have used the psydoname lcd_port no where have i directly referenced it.

i have tried every thing . oter ports work fine for other applications like a stepper motor or keypad etc .. lcd seem to be in love with that particular port . been breaking my head over it for a week.as far as i know there is nothing wrong with the code . but please correct me if i am wrong ..



List of 29 messages in thread
TopicAuthorDate
lcd port switching problem            01/01/70 00:00      
   P0 does not have internal pull-ups            01/01/70 00:00      
   P1 or P2 should work similarly            01/01/70 00:00      
   i do know that about P0            01/01/70 00:00      
      But how about the control defs            01/01/70 00:00      
         yes i have moved them as well            01/01/70 00:00      
         here is the lcd part of the code            01/01/70 00:00      
            correct me if i am wrong            01/01/70 00:00      
               Tried everything?            01/01/70 00:00      
      Again, I guess you are mixing            01/01/70 00:00      
         could you please poin it out in the code            01/01/70 00:00      
   header file            01/01/70 00:00      
      the above show NOTHING, but here is a guess            01/01/70 00:00      
   hardware problem?            01/01/70 00:00      
      errors not consistent            01/01/70 00:00      
         I am somewhat puzzeled...            01/01/70 00:00      
            come conufusion with the file            01/01/70 00:00      
               My suggestion was to...            01/01/70 00:00      
                  will try that michael            01/01/70 00:00      
         Multimeter is enough            01/01/70 00:00      
            will try that out            01/01/70 00:00      
               Tests both sw and hw            01/01/70 00:00      
   lcd simulator (from keil)            01/01/70 00:00      
      i do not know your chip ...            01/01/70 00:00      
         keep in reset as in ?            01/01/70 00:00      
            if open collector supervisor and reset low            01/01/70 00:00      
   the lcd worked on P0 with pull ups            01/01/70 00:00      
      which processor?            01/01/70 00:00      
         AT89C52            01/01/70 00:00      

Back to Subject List