Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/02/08 19:44
Read: times


 		 #158775 - lcd simulator (from keil)
Responding to: ???'s previous message
whole prog works fine (for p1,p2,p2 ) in the LCD simulator ( the dll files were downloaded from the keil website ) so its most likely a hardware problem . is there anything in the 89c52 h/w which prevents it from driving a lcd on any other ports? is the driving current not enough ? wil a unl2003 driver work ?

so only thing left for me is to do what Mr westermark suggested . please do tell me if any other solution exists ?

List of 29 messages in thread
TopicAuthorDate
lcd port switching problem            01/01/70 00:00      
   P0 does not have internal pull-ups            01/01/70 00:00      
   P1 or P2 should work similarly            01/01/70 00:00      
   i do know that about P0            01/01/70 00:00      
      But how about the control defs            01/01/70 00:00      
         yes i have moved them as well            01/01/70 00:00      
         here is the lcd part of the code            01/01/70 00:00      
            correct me if i am wrong            01/01/70 00:00      
               Tried everything?            01/01/70 00:00      
      Again, I guess you are mixing            01/01/70 00:00      
         could you please poin it out in the code            01/01/70 00:00      
   header file            01/01/70 00:00      
      the above show NOTHING, but here is a guess            01/01/70 00:00      
   hardware problem?            01/01/70 00:00      
      errors not consistent            01/01/70 00:00      
         I am somewhat puzzeled...            01/01/70 00:00      
            come conufusion with the file            01/01/70 00:00      
               My suggestion was to...            01/01/70 00:00      
                  will try that michael            01/01/70 00:00      
         Multimeter is enough            01/01/70 00:00      
            will try that out            01/01/70 00:00      
               Tests both sw and hw            01/01/70 00:00      
   lcd simulator (from keil)            01/01/70 00:00      
      i do not know your chip ...            01/01/70 00:00      
         keep in reset as in ?            01/01/70 00:00      
            if open collector supervisor and reset low            01/01/70 00:00      
   the lcd worked on P0 with pull ups            01/01/70 00:00      
      which processor?            01/01/70 00:00      
         AT89C52            01/01/70 00:00      

Back to Subject List