Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/02/08 09:35
Read: times


 		 #158756 - errors not consistent
Responding to: ???'s previous message
as in when connected to one port (say p1 ) i get no display ( but i can make out that that it is not initialized as a two lize display ( its a 20 x 4 display so only the 1st and 3ed line get initialized but noting is displayed on it or some times "000000" 's are displayed ) and on the other port i get garbled display .
while while the same program works perfectly for p3 .


i don't want to sound lazy or anything but i don't have access to a oscilloscope so i can't try out what Westermark suggested .

List of 29 messages in thread
TopicAuthorDate
lcd port switching problem            01/01/70 00:00      
   P0 does not have internal pull-ups            01/01/70 00:00      
   P1 or P2 should work similarly            01/01/70 00:00      
   i do know that about P0            01/01/70 00:00      
      But how about the control defs            01/01/70 00:00      
         yes i have moved them as well            01/01/70 00:00      
         here is the lcd part of the code            01/01/70 00:00      
            correct me if i am wrong            01/01/70 00:00      
               Tried everything?            01/01/70 00:00      
      Again, I guess you are mixing            01/01/70 00:00      
         could you please poin it out in the code            01/01/70 00:00      
   header file            01/01/70 00:00      
      the above show NOTHING, but here is a guess            01/01/70 00:00      
   hardware problem?            01/01/70 00:00      
      errors not consistent            01/01/70 00:00      
         I am somewhat puzzeled...            01/01/70 00:00      
            come conufusion with the file            01/01/70 00:00      
               My suggestion was to...            01/01/70 00:00      
                  will try that michael            01/01/70 00:00      
         Multimeter is enough            01/01/70 00:00      
            will try that out            01/01/70 00:00      
               Tests both sw and hw            01/01/70 00:00      
   lcd simulator (from keil)            01/01/70 00:00      
      i do not know your chip ...            01/01/70 00:00      
         keep in reset as in ?            01/01/70 00:00      
            if open collector supervisor and reset low            01/01/70 00:00      
   the lcd worked on P0 with pull ups            01/01/70 00:00      
      which processor?            01/01/70 00:00      
         AT89C52            01/01/70 00:00      

Back to Subject List