Oops~! I forgot this.........

Will the R/C receiver output "a pulse" or "anything special" to reset/control the Servo motor at the start of power? If so, I should add these pulses to my program so that I can control the driver.

I use the driver instead of the servo. The driver is for those models which are using electricity.(but not oil)

I can now control the servo's angle by 2051, but CAN'T control the driver.(the manual said that it should be the same to connect the driver instead of the servo. The driver increase or decrease the motor power instead of changing the angle of servo)

What's the problem? I can make the driver work again by connect it to the R/C receiver and restart the driver power. After it work, I connect it the the 2051 and it continue working fine. But i restart the driver and the motor stop rotate.

Stanley