Prahlad,

Just some tips for your layout that makes life easier.

Try to avoid 90 degree bends on your tracks. Using two 45 deg bends (or a radius) reduces EMI.

There's very little gain (if any) in having the track run in 30 mils and then reducing it to 13 mil. Keep you tracks even. This will make it esier when you need to change the layout. Of course power tracks need to be as fat as possible.

When laying your board out, try to use only 0, 90 and 45 deg angled tracks as this will make it much easier to change the layout.

Place the crystal caps beside each crystal pin to reduce the track lengths. Your design will probably work but it is good practise to reduce crystal tracks as much as possible.

Good luck with your project.
/P