| ??? 01/08/05 11:57 Read: times |
#84568 - thanks for answer Responding to: ???'s previous message |
You are right!
I think about remote exchange of code. I planed to remotely (USB, RS-485, RS-232) set this apliance in setup connection. Then I want to setup apliance in read mode and send to this new code directly do EEPROM memory. After that a want to send special reset command (maybe any hardware haha "fish eat itself") and when appliance start it will use new software. It is posible in family 80C51? |
| Topic | Author | Date |
| Use SRAM as code memory. | 01/01/70 00:00 | |
| Yes, but | 01/01/70 00:00 | |
| thanks for answer | 01/01/70 00:00 | |
| ibid | 01/01/70 00:00 | |
| There are so many options... | 01/01/70 00:00 | |
| Answer partially wrong: Can't Write CODE | 01/01/70 00:00 | |
| No need for switching | 01/01/70 00:00 | |
| Oh yes... | 01/01/70 00:00 | |
| Take care - wherewer your code is :-) | 01/01/70 00:00 | |
| Once again thanks | 01/01/70 00:00 | |
| Self-modifying code | 01/01/70 00:00 | |
| Self-modifying code - good or bad | 01/01/70 00:00 | |
| Self-modifying code | 01/01/70 00:00 | |
| 90:10 rule | 01/01/70 00:00 | |
| In System Programming Application Note | 01/01/70 00:00 | |
| In-System v. In-Application Programming | 01/01/70 00:00 | |
| IAP v ISP | 01/01/70 00:00 | |
| Philips IAP | 01/01/70 00:00 | |
It's easier with Atmel | 01/01/70 00:00 |