| ??? 01/31/05 20:28 Read: times |
#86239 - Manchester Responding to: ???'s previous message |
I am not using the RF600D chip (for encoding) it is just plain old TTL in (TX to RX) then plain old TTL out.
All i want to know is wether or not i can put the output that would normally come out of P3.0 or 3.1 into the AM-TX. Or if i can use something like P1.1 (serial data bit) opposed to P1. Thanks |
| Topic | Author | Date |
| P1 serial data | 01/01/70 00:00 | |
| Why not use the UART? | 01/01/70 00:00 | |
| Pin 10 and 11 | 01/01/70 00:00 | |
| back to basics | 01/01/70 00:00 | |
| OK | 01/01/70 00:00 | |
| will cost you anyhow | 01/01/70 00:00 | |
| Already Have | 01/01/70 00:00 | |
| What kind od serial data | 01/01/70 00:00 | |
| Type of data | 01/01/70 00:00 | |
| RTFM | 01/01/70 00:00 | |
| Wrong end of stick! | 01/01/70 00:00 | |
| Serial | 01/01/70 00:00 | |
| still unspecific | 01/01/70 00:00 | |
| ROM | 01/01/70 00:00 | |
| a ROM can not map anything | 01/01/70 00:00 | |
| End of wrong stick! | 01/01/70 00:00 | |
| Mystery? | 01/01/70 00:00 | |
| its still a mystery | 01/01/70 00:00 | |
| Module | 01/01/70 00:00 | |
| not yet | 01/01/70 00:00 | |
| UART is not a good choice | 01/01/70 00:00 | |
| Manchester | 01/01/70 00:00 | |
| You didn't get it, but that's OK | 01/01/70 00:00 | |
| The Stick! | 01/01/70 00:00 | |
| OK | 01/01/70 00:00 | |
| Yes | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| Extra UART needed? | 01/01/70 00:00 | |
| Wires? Grounding?? | 01/01/70 00:00 | |
| uC to RF module interface wires | 01/01/70 00:00 | |
| disconnect the MAX232 | 01/01/70 00:00 | |
It looks like a straight tranceiver | 01/01/70 00:00 |