Hi Neil,

I have the datasheet and I read that.I am getting some output,i displayed the digital value in the 7segment led.But the output is not varying,if i vary the input.The input i used here is load(if i increase the load,the value has to vary).I used cs5460A as a SPI inbuilt ADC(i can use no).I have the doubt in configuring the registers of cs5460a.At first i set it command by giving software reset,after that i selected the configuration register,for that i sent 0x40 to the cs5460a via sdi,then i configured the config register by sending 0x000001.then i gave start of conversion command,then i read the status register to check the end of conversion.after this i read the 24bit output from the vge calibration reg.but i am not getting proper output.

Sakthi