| ??? 11/25/07 02:17 Read: times |
#147362 - master slave 8052 configuration |
I am using the AT89LP4052 in a new design. Was planning to design a master that communicates with six slaves which will be located 6' away from the master. wanted to use the four serial pins SCK, MISO, MOSI, and SS<not> pins because the slave's RS232 is assigned to other tasks. The master would enable a slave through the SS pin then send and receive data from that slave. Everything will run off of 3.3 VDC.
My problem is I can't seem to find a IC that will buffer the data to and from (and is bidirectional) and will work at 3.3 VDC. I also have 12 VDC and 5 VDC available on each board so a level translation to the higher voltage along the 6' data cable would also be a plus and provide me some additional ESD protection. Does anybody have a solution to this problem? |
| Topic | Author | Date |
| master slave 8052 configuration | 01/01/70 00:00 | |
| Options | 01/01/70 00:00 | |
| Wait a minute - Bidirectional...? | 01/01/70 00:00 | |
| MOSI TO MOSI | 01/01/70 00:00 | |
| Eh?? | 01/01/70 00:00 | |
| page 40 | 01/01/70 00:00 | |
| Out of date? | 01/01/70 00:00 | |
| Not bidirectional | 01/01/70 00:00 | |
| use RS485 transmitters and receivers | 01/01/70 00:00 | |
| That is not how it works | 01/01/70 00:00 | |
| just clearing it up | 01/01/70 00:00 | |
| UART tied up - EZ-LCD rate question | 01/01/70 00:00 | |
| crystal frequencies and timer 1 reload values | 01/01/70 00:00 | |
| A common crystal | 01/01/70 00:00 | |
| what is confusing? | 01/01/70 00:00 | |
| Synonyms | 01/01/70 00:00 | |
| crystal chosen | 01/01/70 00:00 | |
| read, READ, read the thread | 01/01/70 00:00 | |
| read-ed | 01/01/70 00:00 | |
| Kiel calculator revisit | 01/01/70 00:00 | |
| correct, but there is s small problem | 01/01/70 00:00 | |
| yes device differs | 01/01/70 00:00 | |
| unless you have a very fast micro ... | 01/01/70 00:00 | |
ATMEL Baud rate calculator | 01/01/70 00:00 |