| ??? 11/29/07 04:23 Read: times |
#147539 - UART tied up - EZ-LCD rate question Responding to: ???'s previous message |
The UART in the slave boards will be tied up communicating with EZ-LCD displays. I decided to use the "bit bang" method for the general communications between the master and slaves. Low speed opto's to receive and S to P OC drivers to send. VERY slow data rate.
The EZ-LCD calls for a baud rate of 115200 bps and I can't find a list of crystal frequencies and timer 1 reload values to obtain this baud rate using mode 1 with the AT89LP4052. Anybody have those figures handy? |
| Topic | Author | Date |
| master slave 8052 configuration | 01/01/70 00:00 | |
| Options | 01/01/70 00:00 | |
| Wait a minute - Bidirectional...? | 01/01/70 00:00 | |
| MOSI TO MOSI | 01/01/70 00:00 | |
| Eh?? | 01/01/70 00:00 | |
| page 40 | 01/01/70 00:00 | |
| Out of date? | 01/01/70 00:00 | |
| Not bidirectional | 01/01/70 00:00 | |
| use RS485 transmitters and receivers | 01/01/70 00:00 | |
| That is not how it works | 01/01/70 00:00 | |
| just clearing it up | 01/01/70 00:00 | |
| UART tied up - EZ-LCD rate question | 01/01/70 00:00 | |
| crystal frequencies and timer 1 reload values | 01/01/70 00:00 | |
| A common crystal | 01/01/70 00:00 | |
| what is confusing? | 01/01/70 00:00 | |
| Synonyms | 01/01/70 00:00 | |
| crystal chosen | 01/01/70 00:00 | |
| read, READ, read the thread | 01/01/70 00:00 | |
| read-ed | 01/01/70 00:00 | |
| Kiel calculator revisit | 01/01/70 00:00 | |
| correct, but there is s small problem | 01/01/70 00:00 | |
| yes device differs | 01/01/70 00:00 | |
| unless you have a very fast micro ... | 01/01/70 00:00 | |
ATMEL Baud rate calculator | 01/01/70 00:00 |