| ??? 12/01/09 12:50 Read: times |
#171340 - Modbus |
Hello all,
I am trying to interface 89S52 with PLC port working at modbus. I have made the packet that is to send to PLC. The output of MCU is fine, as it is tested at hyper terminal but there is no response from the PLC. What could be the problem...? Please explain... |
| Topic | Author | Date |
| Modbus | 01/01/70 00:00 | |
| What testing have you done? | 01/01/70 00:00 | |
| Don't use hyperterminal | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Still lots of debugging left | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| Not very helpful | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| Still need to break the problem down into smaller steps | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Parity | 01/01/70 00:00 | |
| Oscilloscope results? | 01/01/70 00:00 | |
| open source | 01/01/70 00:00 | |
| Also RTU Framing | 01/01/70 00:00 | |
| Framing, addressing etc has been discussed | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Bad CRC order!! | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Don't know why, | 01/01/70 00:00 | |
| Comparison with something known working | 01/01/70 00:00 | |
| what device address | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
I would do this... | 01/01/70 00:00 |