| ??? 12/02/09 13:03 Read: times |
#171390 - open source Responding to: ???'s previous message |
Kamran Rasul said:
I have downloaded the utility. In both modes (RTU and ASCII) the modbus time-out message appears. I don't why PLC is not communicating with this utility, however the same register values appear in the other PLC (used to check the register values).
I have constructed the hardware for sniffing the communication of the PLCs. Let see what happens. Thanks. Hai Must pick up the mode..RTU or ASCII. Why din't used PVbrowser.It's open source but must used Opensuse(I'm used Opensuse 11 and there's Qt from trolltech which needed with PVbrowser). Did you used 89S52 with RTU? Kindly share code cause I'm stuck with RTU(89S2 chip alone). Thank's Jeckson Ben |
| Topic | Author | Date |
| Modbus | 01/01/70 00:00 | |
| What testing have you done? | 01/01/70 00:00 | |
| Don't use hyperterminal | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Still lots of debugging left | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| Not very helpful | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| Still need to break the problem down into smaller steps | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Parity | 01/01/70 00:00 | |
| Oscilloscope results? | 01/01/70 00:00 | |
| open source | 01/01/70 00:00 | |
| Also RTU Framing | 01/01/70 00:00 | |
| Framing, addressing etc has been discussed | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Bad CRC order!! | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Don't know why, | 01/01/70 00:00 | |
| Comparison with something known working | 01/01/70 00:00 | |
| what device address | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
I would do this... | 01/01/70 00:00 |