| ??? 12/02/09 11:28 Read: times |
#171385 - modbus Responding to: ???'s previous message |
I have downloaded the utility. In both modes (RTU and ASCII) the modbus time-out message appears. I don't why PLC is not communicating with this utility, however the same register values appear in the other PLC (used to check the register values).
I have constructed the hardware for sniffing the communication of the PLCs. Let see what happens. Thanks. |
| Topic | Author | Date |
| Modbus | 01/01/70 00:00 | |
| What testing have you done? | 01/01/70 00:00 | |
| Don't use hyperterminal | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Still lots of debugging left | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| Not very helpful | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| Still need to break the problem down into smaller steps | 01/01/70 00:00 | |
| Modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Parity | 01/01/70 00:00 | |
| Oscilloscope results? | 01/01/70 00:00 | |
| open source | 01/01/70 00:00 | |
| Also RTU Framing | 01/01/70 00:00 | |
| Framing, addressing etc has been discussed | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Bad CRC order!! | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
| Don't know why, | 01/01/70 00:00 | |
| Comparison with something known working | 01/01/70 00:00 | |
| what device address | 01/01/70 00:00 | |
| modbus | 01/01/70 00:00 | |
I would do this... | 01/01/70 00:00 |