hey Brother cool

>NO! Your routing plan showed, that all nodes are >located to each other like sitting on a chain. Then, >ground loops cannot be formed!
////// Should I follow your joining Cable shield at one stub only in this situation or joine at both stubs.\

>So, 110VDC isn't dangerous??? And what about voltage >of battery RELATIVE to bus chassis? What about >leakage currents flowing from high voltage section to >battery???
////// Leakage current is hardly a problem ,they said their purpose to keep chasis floating is to enable atleast two earth faults for the system to trip and the system should work even with single earth fault .\\

>Then bus chassis would see a connection to signal >ground.
/////// Yea thats it . I will use TEFLON(R) screws at the bottom or a plastic chassis . \\\

>ONLY APPROVED SAFETY ENGINEER CAN DECIDE HOW >TO >PROCEED!!!!! Did you contact him already?
/////Naa ,the manufacturer decide what to do he told me not to put the signal ground on the chassis .But he told me to use chassis as it is for anything . I wanna ask you *WHAT * to do with the chassis could it be treated as PE or Dirt .And Shield tied to it at one point there , No 0v connection here .


>You are playing with the health of other people and >so, you must be absolutely sure, what you are >doing!!! Becomes a person hearted or killed, because >you made a mistake, you will be sent into prison!

///////Hey Bro thats why I am here and asking so much and taking everyone opinion\\

Kindly/