| ??? 10/31/03 16:50 Read: times |
#57608 - RE: it's a dirty job - Erik Responding to: ???'s previous message |
Sorry about the truncated model code - the complete model is ICM 7218A from Intersil. Maybe others like Harris or Maxim may have it. Yes, leading the opto coupler signal all the way from the drive end to the panel is a challange to keep it clean and sharp. However that is something that has been resolved - the signal at the output of the final CD4093 ( Schimdt trigger gate ) that is connected to the P1.0 of the MCU is quite clean. Raghu |
| Topic | Author | Date |
| 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM - Babar | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM - Peter | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM - Peter | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM - two notes | 01/01/70 00:00 | |
| it's a dirty job | 01/01/70 00:00 | |
| RE: it's a dirty job - Erik | 01/01/70 00:00 | |
| RE: it's a dirty job - Erik | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
| RE: 100 to 3600 RPM | 01/01/70 00:00 | |
RE: 100 to 3600 RPM | 01/01/70 00:00 |