| ??? 02/15/05 14:39 Read: times |
#87522 - I think you do not load Responding to: ???'s previous message |
This code works perfectly using an Analog ADUC812 development board
I think you do not load the program, try this org 0 mov p2,#0 jmp 0 This will drive p2 pins low if you actually manage to get the code to the processor and the processor to run. Another possibility is, of course, that you do not get out of reset. Erik |
| Topic | Author | Date |
| Problem getting 8051 chip to work | 01/01/70 00:00 | |
| tie ~EA pin to Vcc | 01/01/70 00:00 | |
| tie Vpp/~EA pin to Vcc | 01/01/70 00:00 | |
| to connect or not? | 01/01/70 00:00 | |
| conbnect | 01/01/70 00:00 | |
| If it helps.... | 01/01/70 00:00 | |
| Reset Capacitor | 01/01/70 00:00 | |
| connect | 01/01/70 00:00 | |
| T89C51RD2 | 01/01/70 00:00 | |
| This device is ISP | 01/01/70 00:00 | |
| VCC and GND? | 01/01/70 00:00 | |
| I think you do not load | 01/01/70 00:00 | |
| Series resistor for LED? | 01/01/70 00:00 | |
| 74F14 | 01/01/70 00:00 | |
| give me +1 too | 01/01/70 00:00 | |
| done | 01/01/70 00:00 | |
| Sorry | 01/01/70 00:00 | |
| LED Polarity | 01/01/70 00:00 | |
| Does not seem to be the cause | 01/01/70 00:00 | |
| Ouch! | 01/01/70 00:00 | |
| FAST-TTL and breadboarded design | 01/01/70 00:00 | |
| Ground bounce | 01/01/70 00:00 | |
| Bad news 74F =( | 01/01/70 00:00 | |
| HCT? | 01/01/70 00:00 | |
| LS, HCT and maybe AHCT | 01/01/70 00:00 | |
| Got it | 01/01/70 00:00 | |
| wire wrap and breadboards | 01/01/70 00:00 | |
| I use protoboard | 01/01/70 00:00 | |
| the problem with that is | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| Why do you want to use 74F chips? | 01/01/70 00:00 | |
well... | 01/01/70 00:00 | |
| maybe you are still in ISP mode? | 01/01/70 00:00 | |
| 1st things 1st please | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| bounce on non PCB | 01/01/70 00:00 | |
| Analytical thinking | 01/01/70 00:00 |