Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/16/05 13:55
Read: times


 
#87647 - bounce on non PCB
Responding to: ???'s previous message
As far as I know a S or an AL chip will do me for this also and I was just wondering if there is likely to be any problem with ground bounce with these. (And before anybody says to read the datasheet I already have, but I didn't pick up on this problem when I read the datasheet for the F chip so ...)
No one should say "read the datasheet" cause this aint there. 'S' and 'AL' are both very bad for breadboarding, use HC for 'regular' use and HCT for TTL interfacing.

Erik

List of 37 messages in thread
TopicAuthorDate
Problem getting 8051 chip to work            01/01/70 00:00      
   tie ~EA pin to Vcc            01/01/70 00:00      
      tie Vpp/~EA pin to Vcc            01/01/70 00:00      
         to connect or not?            01/01/70 00:00      
            conbnect            01/01/70 00:00      
            If it helps....            01/01/70 00:00      
               Reset Capacitor            01/01/70 00:00      
            connect            01/01/70 00:00      
      T89C51RD2            01/01/70 00:00      
         This device is ISP            01/01/70 00:00      
   VCC and GND?            01/01/70 00:00      
   I think you do not load            01/01/70 00:00      
   Series resistor for LED?            01/01/70 00:00      
      74F14            01/01/70 00:00      
         give me +1 too            01/01/70 00:00      
            done            01/01/70 00:00      
      Sorry            01/01/70 00:00      
         LED Polarity            01/01/70 00:00      
            Does not seem to be the cause            01/01/70 00:00      
   Ouch!            01/01/70 00:00      
      FAST-TTL and breadboarded design            01/01/70 00:00      
         Ground bounce            01/01/70 00:00      
            Bad news 74F =(            01/01/70 00:00      
               HCT?            01/01/70 00:00      
                  LS, HCT and maybe AHCT            01/01/70 00:00      
            Got it            01/01/70 00:00      
               wire wrap and breadboards            01/01/70 00:00      
                  I use protoboard            01/01/70 00:00      
                     the problem with that is            01/01/70 00:00      
                        Thanks            01/01/70 00:00      
                     Why do you want to use 74F chips?            01/01/70 00:00      
                        well...            01/01/70 00:00      
   maybe you are still in ISP mode?            01/01/70 00:00      
   1st things 1st please            01/01/70 00:00      
   Thanks            01/01/70 00:00      
      bounce on non PCB            01/01/70 00:00      
   Analytical thinking            01/01/70 00:00      

Back to Subject List