| ??? 02/15/05 21:47 Read: times |
#87591 - LED Polarity Responding to: ???'s previous message |
Ray Carey said:
I have a 270ohm resistor in series with the LED. I always had it there, just forgot to put it in the schematic (has been updated now). Is the LED polarity also just a "typo" ? |
| Topic | Author | Date |
| Problem getting 8051 chip to work | 01/01/70 00:00 | |
| tie ~EA pin to Vcc | 01/01/70 00:00 | |
| tie Vpp/~EA pin to Vcc | 01/01/70 00:00 | |
| to connect or not? | 01/01/70 00:00 | |
| conbnect | 01/01/70 00:00 | |
| If it helps.... | 01/01/70 00:00 | |
| Reset Capacitor | 01/01/70 00:00 | |
| connect | 01/01/70 00:00 | |
| T89C51RD2 | 01/01/70 00:00 | |
| This device is ISP | 01/01/70 00:00 | |
| VCC and GND? | 01/01/70 00:00 | |
| I think you do not load | 01/01/70 00:00 | |
| Series resistor for LED? | 01/01/70 00:00 | |
| 74F14 | 01/01/70 00:00 | |
| give me +1 too | 01/01/70 00:00 | |
| done | 01/01/70 00:00 | |
| Sorry | 01/01/70 00:00 | |
| LED Polarity | 01/01/70 00:00 | |
| Does not seem to be the cause | 01/01/70 00:00 | |
| Ouch! | 01/01/70 00:00 | |
| FAST-TTL and breadboarded design | 01/01/70 00:00 | |
| Ground bounce | 01/01/70 00:00 | |
| Bad news 74F =( | 01/01/70 00:00 | |
| HCT? | 01/01/70 00:00 | |
| LS, HCT and maybe AHCT | 01/01/70 00:00 | |
| Got it | 01/01/70 00:00 | |
| wire wrap and breadboards | 01/01/70 00:00 | |
| I use protoboard | 01/01/70 00:00 | |
| the problem with that is | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| Why do you want to use 74F chips? | 01/01/70 00:00 | |
well... | 01/01/70 00:00 | |
| maybe you are still in ISP mode? | 01/01/70 00:00 | |
| 1st things 1st please | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| bounce on non PCB | 01/01/70 00:00 | |
| Analytical thinking | 01/01/70 00:00 |