| ??? 02/16/05 22:57 Read: times |
#87717 - I use protoboard Responding to: ???'s previous message |
I tought a protoboard was a breadboard. I call it protoboard but i read most of the people refers a breadboard, i assumed it was the same because of the different language
I am going to use a Clock signal of 2.048Mhz, i hope those 74HCT doesn't cause me any trouble. I would be happy if i could use some 74F with a protoboard, i will try and see what happens |
| Topic | Author | Date |
| Problem getting 8051 chip to work | 01/01/70 00:00 | |
| tie ~EA pin to Vcc | 01/01/70 00:00 | |
| tie Vpp/~EA pin to Vcc | 01/01/70 00:00 | |
| to connect or not? | 01/01/70 00:00 | |
| conbnect | 01/01/70 00:00 | |
| If it helps.... | 01/01/70 00:00 | |
| Reset Capacitor | 01/01/70 00:00 | |
| connect | 01/01/70 00:00 | |
| T89C51RD2 | 01/01/70 00:00 | |
| This device is ISP | 01/01/70 00:00 | |
| VCC and GND? | 01/01/70 00:00 | |
| I think you do not load | 01/01/70 00:00 | |
| Series resistor for LED? | 01/01/70 00:00 | |
| 74F14 | 01/01/70 00:00 | |
| give me +1 too | 01/01/70 00:00 | |
| done | 01/01/70 00:00 | |
| Sorry | 01/01/70 00:00 | |
| LED Polarity | 01/01/70 00:00 | |
| Does not seem to be the cause | 01/01/70 00:00 | |
| Ouch! | 01/01/70 00:00 | |
| FAST-TTL and breadboarded design | 01/01/70 00:00 | |
| Ground bounce | 01/01/70 00:00 | |
| Bad news 74F =( | 01/01/70 00:00 | |
| HCT? | 01/01/70 00:00 | |
| LS, HCT and maybe AHCT | 01/01/70 00:00 | |
| Got it | 01/01/70 00:00 | |
| wire wrap and breadboards | 01/01/70 00:00 | |
| I use protoboard | 01/01/70 00:00 | |
| the problem with that is | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| Why do you want to use 74F chips? | 01/01/70 00:00 | |
well... | 01/01/70 00:00 | |
| maybe you are still in ISP mode? | 01/01/70 00:00 | |
| 1st things 1st please | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| bounce on non PCB | 01/01/70 00:00 | |
| Analytical thinking | 01/01/70 00:00 |