| ??? 02/14/07 22:19 Read: times |
#132998 - this depends on the COM port settings... Responding to: ???'s previous message |
... on the PC side.
What you refer to is what happens if the "hardware handshake" is on. IIRC this is discussed in enough detail in Jon's document. That covers pretty much of the topic, with enough stress on troubleshooting, at least for the beginners - except perhaps the interrupt-driven Rx/Tx (or have you already changed on that, Jon?) - but that's not a beginner's issue anyway, is it... JW |
| Topic | Author | Date |
| problem in connecting 89c51rd2 to computer | 01/01/70 00:00 | |
| Some help | 01/01/70 00:00 | |
| Checklist? | 01/01/70 00:00 | |
| Caslav is missing the 'typical' case | 01/01/70 00:00 | |
| Sorry, I should have been more specific :) | 01/01/70 00:00 | |
| then the burden caps is not your problem | 01/01/70 00:00 | |
| Don't these cables need some tiebacks? | 01/01/70 00:00 | |
| this depends on the COM port settings... | 01/01/70 00:00 | |
| No | 01/01/70 00:00 | |
| Handshake doesn't appear in the document | 01/01/70 00:00 | |
| OK, "flow control"... | 01/01/70 00:00 | |
| any help with 89c51rd2fn programming?? | 01/01/70 00:00 | |
| Yes | 01/01/70 00:00 | |
| @site administrator | 01/01/70 00:00 | |
But, what was the solution?? | 01/01/70 00:00 | |
| Buy 89c51rd2 Kit | 01/01/70 00:00 | |
| from Phytec | 01/01/70 00:00 |