Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
11/06/09 13:05
Read: times


 		 #170501 - wrong approach
Responding to: ???'s previous message
LM1086 is almost 2 USD !! I have been observing the output of LM317, and it has been stable at 3.2 to 3.3 volts.
reducing cost by going outside the datasheet is not reducing cost, it is delaying cost till the requests for RMAs come in.

To reduce the cost, I thought of using 3 diodes and then switched to LM317 after checking the performance, even though I was worried about the drop-out band in the border region.
not a good approach either.

Erik



List of 30 messages in thread
TopicAuthorDate
C2 debugger interface resets when ground pin is touched            01/01/70 00:00      
   Flash operations            01/01/70 00:00      
      one point            01/01/70 00:00      
         WDT and flash            01/01/70 00:00      
            do you have a 4 layer board, is the PC and ...            01/01/70 00:00      
               GSM modem, not PC..            01/01/70 00:00      
                  Floating signals            01/01/70 00:00      
                  PC "ground" loop?            01/01/70 00:00      
                     That is a good point!!            01/01/70 00:00      
                  Perhaps you should "AC-couple" signal GND to "earth"            01/01/70 00:00      
   Maybe your compy USB is flakey?            01/01/70 00:00      
      apples and oranges            01/01/70 00:00      
   No surprise at all!            01/01/70 00:00      
      Actually, it resets when I am nowhere near it also.            01/01/70 00:00      
         Unfortunately,...            01/01/70 00:00      
         Section 11.3 of the datasheet            01/01/70 00:00      
            known as 'design specifications'            01/01/70 00:00      
               Another clarification..            01/01/70 00:00      
               Design specs eh            01/01/70 00:00      
                  which is ridiculous and "asking for it"            01/01/70 00:00      
                     SICKLabs...            01/01/70 00:00      
                     /RST cap            01/01/70 00:00      
   Your power supply looks instable?            01/01/70 00:00      
      Unstable supply?            01/01/70 00:00      
         Supply            01/01/70 00:00      
            wrong approach            01/01/70 00:00      
         good catch AP            01/01/70 00:00      
      Indeed!            01/01/70 00:00      
      An easy test            01/01/70 00:00      
         oh, but it does            01/01/70 00:00      

Back to Subject List