Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/10/04 22:22
Read: times


 
#64450 - RE: andy neil
Responding to: ???'s previous message
Thus, the read process goes something like:

1. Cause the edge
2. (wait a little while)
3. Read the bit

This is clearly illustrated in Figure 22 on p18 of the data sheet link that you yourself provided:
http://www.8052.com/forum/read.phtml?id=64360

List of 25 messages in thread
TopicAuthorDate
adc interfacing.            01/01/70 00:00      
   RE: adc interfacing.            01/01/70 00:00      
   RE: adc interfacing.            01/01/70 00:00      
   RE: adc interfacing.            01/01/70 00:00      
      RE: adc interfacing.            01/01/70 00:00      
      UART Shift Register mode            01/01/70 00:00      
      Read each bit in turn            01/01/70 00:00      
         RE: andy neil            01/01/70 00:00      
            RE: andy neil            01/01/70 00:00      
               RE: andy neil            01/01/70 00:00      
         RE: Read each bit in turn            01/01/70 00:00      
            RE: michael neary            01/01/70 00:00      
            RE: Read each bit in turn            01/01/70 00:00      
               RE: Read each bit in turn            01/01/70 00:00      
               RE: Read each bit in turn            01/01/70 00:00      
      RE: adc interfacing.            01/01/70 00:00      
         Correction:            01/01/70 00:00      
         RE: ashish pradhan            01/01/70 00:00      
            RE: ashish pradhan            01/01/70 00:00      
               RE: ashish pradhan            01/01/70 00:00      
                  RE: ashish pradhan            01/01/70 00:00      
                     RE: ashish pradhan            01/01/70 00:00      
                     RE: ashish pradhan            01/01/70 00:00      
   RE: adc interfacing.            01/01/70 00:00      
      RE: adc interfacing.            01/01/70 00:00      

Back to Subject List