Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
03/05/05 15:52
Read: times


 		 #89162 - Is it unity gain buffer or I to V conv.
Responding to: ???'s previous message
Dear Kai,

I read almost all Op-amp appliaction notes I have on my hard disk. The first section of the schematic you poasted is exactly like the Current to Voltage converter schematic in "National" Op-Amp application guide. But whats this circuit doing here.

It also looks very much like a unity gain buffer. Is it? If yes then why is the signal input to "Inverting input"? You have shown a 13k fixed resistor + 4k7 pot whats the significance of this resistor value? I am very confused kindly reply to my post and clear my doubts.

Thnaks & Regards,
Prahlad Purohit


List of 37 messages in thread
TopicAuthorDate
Three Gains?            01/01/70 00:00      
   Digital Pots            01/01/70 00:00      
      Re: Digital Pots.            01/01/70 00:00      
         precision digital pots can not be found            01/01/70 00:00      
   PGA are cheap too            01/01/70 00:00      
      Easiest Method            01/01/70 00:00      
         Re: Easiest method.            01/01/70 00:00      
            Need not to be a problem            01/01/70 00:00      
            Three gains            01/01/70 00:00      
               precision            01/01/70 00:00      
                  ratio is precision            01/01/70 00:00      
      Re: PGA            01/01/70 00:00      
   could you            01/01/70 00:00      
      Re: Logarithmic Amplifier.            01/01/70 00:00      
         never used one            01/01/70 00:00      
   Use three independent lines            01/01/70 00:00      
      Re: Three Independent Lines.            01/01/70 00:00      
         Not three integrators, but...            01/01/70 00:00      
            Re: Three Amp sections for three gains            01/01/70 00:00      
               Is it unity gain buffer or I to V conv.            01/01/70 00:00      
                  it's part of your rectifier            01/01/70 00:00      
                     Thanks for clarification.            01/01/70 00:00      
               Maybe some protection scheme for ADC            01/01/70 00:00      
                  Re: Some protection for ADC.            01/01/70 00:00      
   Higher resolution avoids gain switcing            01/01/70 00:00      
      Re: Higher Resolution.            01/01/70 00:00      
   You can use better profesional method.            01/01/70 00:00      
      low voltage analog switching            01/01/70 00:00      
         Re: Low voltage analog switch.            01/01/70 00:00      
            voltage            01/01/70 00:00      
            Seebeck-effect, thermo elements            01/01/70 00:00      
               better - yes            01/01/70 00:00      
               English english            01/01/70 00:00      
                  Re: English            01/01/70 00:00      
                  Thanks!            01/01/70 00:00      
      Re: Profesional method.            01/01/70 00:00      
         Mechanical relays.            01/01/70 00:00      

Back to Subject List