| ??? 09/22/05 10:32 Read: times |
#101363 - Another happy FTDI user Responding to: ???'s previous message |
I would also recommend the FTDI chips as you can connect the 485 driver controls directly to the USB to 232 bridge chip.
Isn't the point about the turnaround time that the master must go from transmit to receive in less time than the slave. In fact all devices must have a receive to transmit delay longer than the slowest transmit to receive delay of any device on the bus. |
| Topic | Author | Date |
| Delay times for switching RS485 lines? | 01/01/70 00:00 | |
| MODBUS | 01/01/70 00:00 | |
| Driver enable and disable time | 01/01/70 00:00 | |
| caution | 01/01/70 00:00 | |
| delay time | 01/01/70 00:00 | |
| make a master | 01/01/70 00:00 | |
| I don't think it is the problem | 01/01/70 00:00 | |
| not the PC, not the windows | 01/01/70 00:00 | |
| Thank you all | 01/01/70 00:00 | |
| non-pc master | 01/01/70 00:00 | |
| Check out the FTDI serial chip | 01/01/70 00:00 | |
| CRC? | 01/01/70 00:00 | |
| CRC? | 01/01/70 00:00 | |
I see | 01/01/70 00:00 | |
| Another happy FTDI user | 01/01/70 00:00 | |
| USB as mentioned below sounds good, but | 01/01/70 00:00 |