Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/22/05 11:52
Read: times


 		 #88139 - Anything for PCB manufacturing
Responding to: ???'s previous message
Jan,

Did you note that they accept only RS-274X or 274-D for double sided board. Any thing else except these types gives registration errors.

Any file type (except gerber) is good only for SS boards without holes, as they say.

Manufacturers here too don't accept anything except gerber/ema for DS boards.

List of 32 messages in thread
TopicAuthorDate
trading PCBs            01/01/70 00:00      
   ISA SCSI Controller            01/01/70 00:00      
      how do you want t he artwork            01/01/70 00:00      
         Hmmm,,,,,            01/01/70 00:00      
            im sorry            01/01/70 00:00      
               Where's that, then?            01/01/70 00:00      
   Nice idea, but            01/01/70 00:00      
      not without a gerber            01/01/70 00:00      
          CIRCAD'98 Rated best PCB software avail            01/01/70 00:00      
            Best            01/01/70 00:00      
         PCB makers            01/01/70 00:00      
            Really ?            01/01/70 00:00      
               The another side of moon, sorry earth            01/01/70 00:00      
                  Anything for PCB manufacturing            01/01/70 00:00      
                     Re: anything for PCB...            01/01/70 00:00      
                        an unqualified answer            01/01/70 00:00      
                           Gerbtool            01/01/70 00:00      
                        Editing Gerber Files? DO NOT DO IT            01/01/70 00:00      
                           But which format, then?            01/01/70 00:00      
                              DXF ?            01/01/70 00:00      
                                 EDIF?            01/01/70 00:00      
                                    ?            01/01/70 00:00      
                                       Introduction to EDIF            01/01/70 00:00      
                                          Ta.            01/01/70 00:00      
                              Re: But which format, then?            01/01/70 00:00      
                                 open source designs            01/01/70 00:00      
                                    Editing published PCBs            01/01/70 00:00      
                           Don't Do It!            01/01/70 00:00      
   re: Editing Gerber Files? DO NOT DO IT            01/01/70 00:00      
      Another corrolary            01/01/70 00:00      
         Unified Theory            01/01/70 00:00      
            Thanks            01/01/70 00:00      

Back to Subject List