Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/24/05 21:00
Read: times


 		 #88387 - Thanks
Responding to: ???'s previous message
Andy Neil said:
The documentation is wrong.


Thanks. Good example of the K.I.S.S. principle. :)

Regards,
Craig Steiner


List of 32 messages in thread
TopicAuthorDate
trading PCBs            01/01/70 00:00      
   ISA SCSI Controller            01/01/70 00:00      
      how do you want t he artwork            01/01/70 00:00      
         Hmmm,,,,,            01/01/70 00:00      
            im sorry            01/01/70 00:00      
               Where's that, then?            01/01/70 00:00      
   Nice idea, but            01/01/70 00:00      
      not without a gerber            01/01/70 00:00      
          CIRCAD'98 Rated best PCB software avail            01/01/70 00:00      
            Best            01/01/70 00:00      
         PCB makers            01/01/70 00:00      
            Really ?            01/01/70 00:00      
               The another side of moon, sorry earth            01/01/70 00:00      
                  Anything for PCB manufacturing            01/01/70 00:00      
                     Re: anything for PCB...            01/01/70 00:00      
                        an unqualified answer            01/01/70 00:00      
                           Gerbtool            01/01/70 00:00      
                        Editing Gerber Files? DO NOT DO IT            01/01/70 00:00      
                           But which format, then?            01/01/70 00:00      
                              DXF ?            01/01/70 00:00      
                                 EDIF?            01/01/70 00:00      
                                    ?            01/01/70 00:00      
                                       Introduction to EDIF            01/01/70 00:00      
                                          Ta.            01/01/70 00:00      
                              Re: But which format, then?            01/01/70 00:00      
                                 open source designs            01/01/70 00:00      
                                    Editing published PCBs            01/01/70 00:00      
                           Don't Do It!            01/01/70 00:00      
   re: Editing Gerber Files? DO NOT DO IT            01/01/70 00:00      
      Another corrolary            01/01/70 00:00      
         Unified Theory            01/01/70 00:00      
            Thanks            01/01/70 00:00      

Back to Subject List