Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
11/16/05 13:18
Read: times


 		 #103793 - All fail safe is good and 0.25V is plent
Responding to: ???'s previous message
To me this sounds like an objection to the use of fail-safe biasing in general, rather than an issue with the way I have proposed to only drive the line low.
All fail safe is good and 0.25V is plenty, the differential nature of the bus makes it more than enough. Just look at LVDS.

The problem with your proposal is that you will need to "violate" the differential nature of the bus which opens a totally different can of worms.

Erik



List of 34 messages in thread
TopicAuthorDate
RS485 Question            01/01/70 00:00      
   drive capacity            01/01/70 00:00      
      3 resistor termination            01/01/70 00:00      
         Only if you have power to burn            01/01/70 00:00      
            15 milliwatts. A lot of power?            01/01/70 00:00      
               Depends on your application            01/01/70 00:00      
                  how are you going to terminate at that            01/01/70 00:00      
                  RS485 loops are hungry...            01/01/70 00:00      
      You will loose all the noise margin!            01/01/70 00:00      
         not if you use 3 resistor termination            01/01/70 00:00      
            Better, but...            01/01/70 00:00      
               works for me, what do you have that is b            01/01/70 00:00      
                  No disagree...look what weird is planned            01/01/70 00:00      
                     Kai, I did not think you did            01/01/70 00:00      
                        Clarification            01/01/70 00:00      
                           3 resistors or not            01/01/70 00:00      
                              Then is all fail-safe bad?            01/01/70 00:00      
                                 Can you see the difference?            01/01/70 00:00      
                                    Kai, you keep ignoring the fact that RS4            01/01/70 00:00      
                                       I ignore nothing            01/01/70 00:00      
                                          It's the best we have and it works when            01/01/70 00:00      
                                             Yes, but it can fail from time to time            01/01/70 00:00      
                                                I have handled that with isolated RS485            01/01/70 00:00      
                                                   We do already            01/01/70 00:00      
                                                      485-422            01/01/70 00:00      
                                                         I challenge you to find a RS422 driver            01/01/70 00:00      
                                                            In the past.            01/01/70 00:00      
                                 All fail safe is good and 0.25V is plent            01/01/70 00:00      
                           That is not RS485, that is J1708            01/01/70 00:00      
                              trick to get around pseudo non random            01/01/70 00:00      
                                 This won't really help.            01/01/70 00:00      
                              Helpful            01/01/70 00:00      
                                 I am doing that using the Dallas DS2401            01/01/70 00:00      
                                    Yes that is what I am planning            01/01/70 00:00      

Back to Subject List