Hi Kai,

Thank you very much for your suggestions.

Sacrifice the solid ground plane on top layer a bit and place some gound plane also between the signals. There's enough place, and what's important, you still have this solid ground plane on bottom layer. So, you can sacrifice solidity of ground plane of top layer a bit.

I am working on the PCB layout to provide as much as ground possible in between the tracks. But Kai I was worried only about one thing...

I remember I have read it somewhere can't remember where exactly. It says when two tracks are running close to each other than the effective inductance of the traces is reduced to half. Wont it hamper this phenomena if I increase the distance between traces in order to introduce ground in between them.

Thank you very much.

Thanks & Regards,
Prahlad Purohit