Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
08/02/05 17:27
Read: times


 		 #98707 - common GND
Responding to: ???'s previous message
Mehdi,

The schematic capture program that I use (Orcad) would require you to use zero ohm resistors to connect the various grounds together. If you don't use zero ohm resistors, it gives you an error when you try to do the error checking.


Jacob


List of 46 messages in thread
TopicAuthorDate
Timing Firmware!            01/01/70 00:00      
   Err - read the datasheet!            01/01/70 00:00      
      Err - read the datasheet!            01/01/70 00:00      
         I don't understand the problem            01/01/70 00:00      
            dont scare            01/01/70 00:00      
               Jan & Russell            01/01/70 00:00      
                  get a dev board, there is much to learn            01/01/70 00:00      
         simple            01/01/70 00:00      
            Thanks!!!            01/01/70 00:00      
            Not as simple as you said Jan!            01/01/70 00:00      
               not, if you are very sneeky            01/01/70 00:00      
               ignored address            01/01/70 00:00      
                  Thanks Jan            01/01/70 00:00      
   different datasheet            01/01/70 00:00      
   Absolute Maximum Ratings!            01/01/70 00:00      
      3.3V?            01/01/70 00:00      
         3.3 V ??            01/01/70 00:00      
            3.3 V ??            01/01/70 00:00      
               Search Time!            01/01/70 00:00      
                  I agree...            01/01/70 00:00      
                     Dear mehdi            01/01/70 00:00      
                        Thanks            01/01/70 00:00      
                           expensive for large amount of production            01/01/70 00:00      
                              expensive for large amount of production            01/01/70 00:00      
                     Issues - not chips            01/01/70 00:00      
               5V to 3.3V solution            01/01/70 00:00      
                  Eh?            01/01/70 00:00      
                     Andy you are accurate!            01/01/70 00:00      
                  3.9M !!            01/01/70 00:00      
                     Answer Is Wrong!!!!            01/01/70 00:00      
                        that is unsafe and depending on the othe            01/01/70 00:00      
                           I agree...            01/01/70 00:00      
                              I'm at a loss            01/01/70 00:00      
                        Sorry my mistake ...            01/01/70 00:00      
                           rock solid 3.3 to 5            01/01/70 00:00      
         Design decisions.            01/01/70 00:00      
            top-bottom vs. bottom-top            01/01/70 00:00      
   Confidential information?            01/01/70 00:00      
      Andy!            01/01/70 00:00      
   Russell & Jan            01/01/70 00:00      
   0 ohm Resistor?            01/01/70 00:00      
      Isn't it obvious?            01/01/70 00:00      
         EVB!            01/01/70 00:00      
            Star Point            01/01/70 00:00      
               Furthermore            01/01/70 00:00      
      common GND            01/01/70 00:00      

Back to Subject List