Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
07/06/06 13:33
Modified:
  07/06/06 13:34
Read: times


 		 #119734 - you are right - need anothe cuppa
Responding to: ???'s previous message
No, even if there's no tolerance in the transzorbs at all the signal will disappear when the interference exceeds the turn-on voltage.

still morning here

Erik



List of 38 messages in thread
TopicAuthorDate
rs485 connection with 8051            01/01/70 00:00      
   RS 485            01/01/70 00:00      
      I have recommended the above appnote for            01/01/70 00:00      
         Yes, but...            01/01/70 00:00      
            cable shield connection ...            01/01/70 00:00      
               is it P.G. Woodhouse?            01/01/70 00:00      
               Hard and soft grounding            01/01/70 00:00      
                  grounding differential signals            01/01/70 00:00      
                     for such Maxim has 'the cure'            01/01/70 00:00      
                        Also AD & Linear Tech            01/01/70 00:00      
                     PEC            01/01/70 00:00      
                        RS485 using 2 wires only            01/01/70 00:00      
                           Using two wires only            01/01/70 00:00      
                              Thanks Russell Bull            01/01/70 00:00      
                                 Shielding            01/01/70 00:00      
                                    CAT5E - UTP and RS485            01/01/70 00:00      
                                       Cat5E & RS485            01/01/70 00:00      
                                          to shield or not to shiels, that is the            01/01/70 00:00      
                                             Thanks Erik            01/01/70 00:00      
                                             common mode voltage            01/01/70 00:00      
                                                comments to common            01/01/70 00:00      
                                                   Even without any tolerance            01/01/70 00:00      
                                                      you are right - need anothe cuppa            01/01/70 00:00      
                                                      I never tried...            01/01/70 00:00      
                                                         What threshold voltage do you use?            01/01/70 00:00      
                                                Transmitting signal ground and +5V            01/01/70 00:00      
                                       Yes            01/01/70 00:00      
                                          Thanks Russel, Erik and Kai            01/01/70 00:00      
                                             re 485 cabling            01/01/70 00:00      
                                                Slew rate controlled drivers prefered            01/01/70 00:00      
                                                   I agree but do not            01/01/70 00:00      
                                                      Of course, this is no excuse for fumblin            01/01/70 00:00      
                                                   slew rate controlled - low speed ??            01/01/70 00:00      
                                                      there is a graph in one of the 485 appno            01/01/70 00:00      
                                                      250kbps?            01/01/70 00:00      
                                                links to juicy B&B 485 stuff            01/01/70 00:00      
                                                re 485 cabling            01/01/70 00:00      
                                                   you found a better link than the one I            01/01/70 00:00      

Back to Subject List