Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
06/15/08 21:30
Read: times


 		 #155934 - That would probably help, but ...
Responding to: ???'s previous message
a simple (lossy) filter that notches out the nominal frequency of the MAX232 will do the trick just fine. You probably want the same effect at the Gnd pin, where the internal circuitry will produce spikes at nominally the same frequency but different phase.

RE

List of 31 messages in thread
TopicAuthorDate
Resistance in the supply rails            01/01/70 00:00      
   inductor instead of resistor            01/01/70 00:00      
      yes, and no and I think the theory is flawed            01/01/70 00:00      
         Spice?            01/01/70 00:00      
            That would probably help, but ...            01/01/70 00:00      
      That's what I said            01/01/70 00:00      
         Not in the gnd path!            01/01/70 00:00      
            Well ... this normally doesn't work so well, but            01/01/70 00:00      
   If this scheme is used it would also be well to...            01/01/70 00:00      
      This does increase the supply impedance            01/01/70 00:00      
         please clarify with a simple schematic            01/01/70 00:00      
            the bypass cap\'s always go between Vcc and Gnd            01/01/70 00:00      
               Which Vcc, Which gnd            01/01/70 00:00      
                  There's a cap on either side of the resistor(s)            01/01/70 00:00      
                     is it            01/01/70 00:00      
                        Not quite ...            01/01/70 00:00      
                           don't use a resistor in the GND connection            01/01/70 00:00      
                              What >good reason< could this be??            01/01/70 00:00      
                                 What good reason could this be??            01/01/70 00:00      
                                    Using a resistor in the GND connection...            01/01/70 00:00      
                              How would that come to pass?            01/01/70 00:00      
                                 Why should I insert a resistor in the GND line??            01/01/70 00:00      
                                    Seldom andonly if it is of benefit            01/01/70 00:00      
                                       No disagree, but ...            01/01/70 00:00      
                                          The regulator can't pull the Vcc down            01/01/70 00:00      
                                             This has nothing to do with imbalance!            01/01/70 00:00      
                                                Kai, I don\'t disagree ...            01/01/70 00:00      
                                                   Again, do not add any impedance in the GND line            01/01/70 00:00      
   tantalum capacitor across the MAX232 power pins            01/01/70 00:00      
      It's a matter of careful choice            01/01/70 00:00      
      Yes they does            01/01/70 00:00      

Back to Subject List